LOMAX HARD TRI-FOLD TONNEAU COVER | 2016-2019 NISSAN TITAN 6'6" BEDPart #: B1030029
Changing the game, LOMAX Hard Tri-Fold Cover is the epitome of strength with industry changing style. The ultra low profile design and textured matte black or classic diamond plate finish of the truck bed cover merges seamlessly with your pickup truck for a simply irresistible appearance. There is no such thing as too much detail. From the water-shedding design to the easy install and removal, LOMAX Hard Tri-Fold Cover is engineered with performance in mind. This is what a hard folding tonneau cover should be.
- 2016-2019 NISSAN TITAN 6'6" BED
- SLEEK, ULTRA LOW PROFILE DESIGN
- Less than half an inch above the box and blends seamlessly with your truck for a sharp, clean appearance.
- EASY TO OPERATE
- To open, pull cords from either side to release latches
- folding each panel automatically disengages additional locks. Then, secure LOMAX Hard Tri-Fold Cover with integrated storage clips. To close, release storage clips and use built-in handle to unfold panels. The tonneau automatically locks at ten points when closed, keeping your cargo protected and out of sight.
- WEATHERTIGHT SEAL
- The water-shedding design and waterproof hinges route water away from the bed without gutters or drains. The hard folding tonneau overlaps the bed rails with a continuous seal along the entire length of the side rails, preventing elements from entering the truck bed.
- STRONG YET LIGHTWEIGHT
- Extruded aluminum channels support the panels to hold up to 400 pounds of evenly distributed weight, while weighing approximately 50 pounds for a high strength-to-weight ratio.
- INTEGRATED STORAGE CLIPS
- Sleek, retractable storage clips hold tonneau cover secure and vinyl capped, rigid standoffs with rubber pads keep panels properly spaced in the folded position. No adjustments needed.
- SIMPLE INSTALLATION
- Install rails with eight TIGHT BITE Clamps. Slide the hard tonneau cover forward to engage hooks, then lower into retainment brackets. Unfold each panel, truck bed cover locks automatically at ten points when closed. No drilling required.
- EASY TO REMOVE AND REINSTALL
- With LOMAX Cover open and storage clips secured, pull cords on front panel and slide it back to disengage hooks, then lift to remove. Reinstall by sliding tonneau cover forward to engage hooks, then lower into retainment brackets. This folding truck bed cover automatically locks in place.
Check these out:
BAKFLIP G2 07-21 TUNDRA 5'6" W/ DECK RAIL SYS W/O TRAIL SPECIAL EDITION STRG BXS - BAKFLIP G2 07-21 TUNDRA 5'6" W/ DECK RAIL SYS W/O TRAIL SPECIAL EDITION STRG BXS
BAKFLIP G2 14-18 (19 LEG/LIM) SILV/SIERRA 1500/15-19 2500HD/3500HD 6'6" - 226121
BAKFLIP G2 14-18 (19 LEG/LIM) SILV/SIERRA 1500/15-19 2500HD/3500HD 8' - 226122
BAKFLIP G2 HARD FOLDING TONNEAU COVER | 1988-2013 CHEVY/GMC 1500/2500/3500 6.6ft BED